N/A
Standard: £10 + VATMembers/Subscribers: Free
Members/Subscribers, log in to access
The Structural Engineer, Volume 56, Issue 4, 1978
It is difficult to predict the distribution of residual stresses present in an asymmetrical welded fabrication such as a stiffened panel. The problem is further complicated when techniques are employed to minimise the out-of-straightness of the finished article. Since residual compressive stresses are often a source of weakness in a compression member, it is important to allow for this effect when drafting design Codes. The tests reported in the paper form a useful contribution towards this end. However the work could have been considerably more interesting if some additional measurements had been made. G.H. Little and C.D. Bradfield
Annes' case The decision in 'Anns'case continues to draw comment and stimulate controversy. We believe this to be good in itself, good that it brings out the several points of view on its implications and possible consequences and good in that it demonstrates very clearly that structural engineers are not so much concerned about themselves but about people and society at large. Verulam
THE PRESIDENT Peter Dunican, President 1977-78, may well be the last of the Presidents who qualified for membership of the Institution by part-time study and by passing the Graduateship and (former) Associate-Membership examinations. Peter, Dunican, CBE, CEng, FIStructE, FICE, FIEI, was elected to corporate membership in 1946 and transferred to Fellowship in 1959. He became a member of the Council in 1964 following which he served in , a number of Honorary Offices until being appointed a Vice-President in 1971. During those 14 years he served on most of the Standing Committees of the Council and was Chairman of its Education and Examinations, Membership, and Finance and General Purposes Committees.