First published: N/A
Standard: £9 + VAT
An IStructE account gives you access to a world of knowledge. Create a profile to receive details of our unique range of resources, events and training.
Added to basket
Professor A. C. Scordelis writes:
‘I have read with interest the paper by J. E. Gibson and was pleased to note that his computer solution checks the results obtained in an earlier study of mine. Dr. Gibson’s early pioneering work in the development of computer programmes for cylindrical shells and the publication of his books and papers have been a stimulus for
similar work being carried out in the United States.'
A simple design procedure is outlined for calculating the bending moment and torque which will cause a plastic hinge to form in an I-section member. The effect of restraint of warping of the cross-section on the torque carrying capacity is taken into account. Experiments on the torsional strength of I-sections with warping restraint and on the combined action of bending and torsion show the proposed design method to be safe and suitable for the design of I-section members under these conditions.
K.S. Dinno and W. Merchant
The critical stress for a lipped plate of given geometry is normally found by solving a transcendental equation by numerical methods. By assuming that the minimum value of the buckling coefficient occurs when there is no transmission of shear loading from the lip to the flange, a solution can be obtained by a considerably simplified analysis. This is shown to give close agreement to the exact solution for a particular case. The simplified analysis allows the torsional stiffness of the lip to be taken into account; it can be applied to all lip shapes, and to many forms of constraint on the other longitudinal edge of the plate.